Dana 60 Gear Ratios Chart

Dana 60 Gear Ratios Chart – The dana 60 rear end overall strength, plentiful availability, heavy duty housing, strong knuckles, and unsurpassed. Dana 60 read this entire sheet carefully before beginning the installation. The gear ratio at which carrier breaks occur varies, depending on the type of differential. 09/23/2018 magazine in this article category:

Tire Size Gear Ratio Chart

Dana 60 Gear Ratios Chart

The dana 60's ring gear is 9.75 inches in diameter, and the available gear spread ranges from 3.31:1 to 7.17:1. Dana 60 gear ratios | team chevelle we may earn a commission for products purchased through links on this page home forums mechanical transmission. 13 photos dana 60 axles are famously beefy—here’s why!

Learn How To Install A Dana 60 Gear Set With Ring Gear, Pinion Gear, Differential, Bearings And Shims.

A variation of the dana 60 known as a dana 61 was made to accommodate gear ratios that allowed for better fuel mileage. 10 / 12 super 60 rear. A 3.07:1 gear ratio was common for these axles and unachievable in a regular dana 60.

This Offset Meant That A Different Carrier And A.

As you can see from the. If you have a dana 61 with 3.07 gears. Dana axle low ratio case high ratio case dana axle low ratio case high ratio model.

To Allow For The Different Gearing, The Dana 61 Had A Greater Pinion Offset.

This was done as a direct result of the 1973 oil crisis. Dana 60 gears strange engineering offers several options for dana 60 gears ratios. 40 spline inner axle shafts and carriers are made for after market, high performance dana 60 axles;

9 / 229Mm Ring Gear Diameter:

9.75 / 10 super 60 front. 9.75 / 248mm pinion diameter / spline: A dana 60 (d60) ring ring gear measures 9.75 inches.

Magazine Few Rear Axle Configurations Have Been As Widely Accepted By All American Manufacturers As The Dana 60.

Possible ratios can range anywhere from 3.54:1 right up to 7.17:1; Gear set 3.54 ratio, 29 spline pinion ring & pinion only: Correct installation can be the gear</strong> lite or noisy, premature.

Dana Super 60 / 10 Gear View Parts:

For example, if you have a dana 44 axle with a gear ratio of 3.73 and want to install a. If you have a dana 61 with 3.33 or higher gear ratio you need a.160 ring gear spacer, 382a race and outside shims to run 4.56's and up.

Dana 60 Increaded Towing? Page 2 2018+ Jeep Wrangler Forums (JL